Agilent Technologies J3972A - Manual (Page 44)

Local Terminal Configuration
Using a Local Terminal
24
Modify/View Security Values
Use the following procedure to configure items in the Modify/View Security
Values menu:
1. If you want to restrict access to the probe press 2 to access the Modify/View
security values menu item, otherwise skip this section. When you press 2 ,
the Modify/View Security Values menu is displayed, as shown in Figure 2-4.
Figure 2-4: Modify/View Security Values Menu
2. Select each field requiring configuration (one at a time) by pressing its
corresponding number and then entering the values that are appropriate for
your network. Refer to “Access Security” on page 8 for more information on
security.
Allow Packet Press 1 and enter Yes to allow or enter No to not allow
Capture packet capture.
Allow TFTP Press 2 and enter Yes to allow or enter No to not allow
Firmware Downloads TFTP firmware downloading.
3. Press S to save the configuration changes and return to the probe’s Main
Menu. If you want to cancel your current changes and return to the probe’s
Main Menu, press
0 .
Modify/View Security Values Menu - Firmware Rev
1. Allow packet capture Yes
2. Allow TFTP firmware downloads Yes
S. Save changes and exit
0. Cancel changes and exit