Agilent Technologies J3972A - Manual (Page 54)

Local Terminal Configuration
Using a Local Terminal
34
Cell Cell Sychronization is configured as HEC (Header Error
Sychronization Control).
Cell Scrambling Press 2 and then set Cell Scrambling to On or Off.
3. Press S to save the configuration changes and return to the probe’s Main
Menu. If you want to cancel your current changes and return to the probe’s
Main Menu, press
0 .
Use the following procedure to configure items in the Modify/View Interface
Values menu for the second port on the OC-3 ATM interface:
1. Press 3 to access the Modify/View interface values menu item. The
Modify/View Interface Values menu for port 2 is displayed, as shown in
Figure 2-8.
Figure 2-8: Modify/View Interface Values Menu (OC-3 ATM, Port 2)
2. Select each field requiring configuration (one at a time) by pressing its
corresponding number and then entering the values that are appropriate for
your network.
Port Press 1 and then enter the desired OC-3 ATM interface’s port
number to display the OC-3 ATM port’s configuration
parameters along with their current settings. Refer to
“Display Interface Summary” on page 36 for information on
port types and port numbers for the installed interfaces. You
Modify/View Interface Values Menu - Firmware Rev
Interface Type ATM
1. Port 3.1/ATM
2. Port Type Monitor-only
3. Network Type UNI
S. Save changes and exit
0. Cancel changes and exit