Agilent Technologies J3972A - Manual (Page 62)

Installation
42
Installation
This chapter describes how to install Agilent J3919A or J3972A OC-3
ATMProbe. Installing an Agilent probe consists of the following tasks:
z “Selecting a Location” on page 43
z “Installing the Probe” on page 44
z “Connecting the Probe” on page 49
z “Starting the Probe” on page 68
z “Verifying the Installation” on page 69
If you plan to configure the probe from a local terminal and have not yet done so,
go to Chapter 2 “Local Terminal Configuration”, and perform the configuration
now.