ATON A275 - Manual (Page 15)

A T O N
Page 8 © ATON 2010 • All rights reserved.
A275
INSTALLATION MANUAL
Chapter 3: Connections
The A275 has several rear panel connections so it is important to label all cables and wires correctly. Label all input/output cable and
speaker wires with their destination or source. This will save time during installation and any future upgrades to the system.
Use high quality line level RCA connector type cables for source connections to ensure the lowest possible noise and best sound per-
formance. For most applications use 16AWG 2 conductor speaker cable. For wiring runs longer than 80 ft. it is recommended to use
14AWG 2 conductor speaker cable. The A275's high quality, gold plated 5-way binding post will accommodate speaker cabling sizes up
to 12AWG. Attaching banana plugs will enable the connection of larger cable sizes. A 3.5mm mono interconnect cable may be used for
amplifier and systems triggering.
Line Level Audio Inputs
Connect the zones by inserting the RCA connectors into the dedicated direct input jack on each channel.
A275
From Audio
Output Source
RCA Patch
Cable
Figure 3-1: Line Inputs