ATON A275 - Manual (Page 17)

A T O N
Page 10 © ATON 2010 • All rights reserved.
A275
INSTALLATION MANUAL
Speaker Binding Post
The A275 is equipped with gold plated, 5-way speaker binding posts. This allows five methods of speaker wire termination: bare wire,
spade lug, pin, single banana and dual banana plug. Label all speaker wires with their destination to ensure easy configuration. To attach
speaker wires use the following method:
1. Carefully split the speaker wire insulation at least two inches.
2. Strip 1/2 inch of the insulation from the speaker wire conductor exposing the bare wire.
3. Twist the wire strands of each conductor, if using banana plugs, attach wire to banana plug observing polarity.
4. If using banana plug; insert plug ends into binding post observing correct polarity. If using the bare wire method; loosen the
binding post caps and insert the bare wire through the hole in the post. Tighten the knob until the wire is securely clamped.
CAUTION! Speaker Wire connections must be made with the amplifier OFF!
Banana Plugs
Speaker Wire
A275 Amplifier
Binding Post
WARNING: Do not allow any strands
of the bare speaker wire to touch
the Amplifier Chassis or another
Connector.
Speaker Wire
1/2’
WHITE
GREEN
RED
BLACK
Figure 3-3: Speaker Binding Post