ATON A275 - Manual (Page 4)

A T O N
© ATON 2010 • All rights reserved. Page III
A275
INSTALLATION MANUAL
Cleaning
—Unplug the apparatus from the power outlet before cleaning. Use only a dry cloth to clean the apparatus.
Power Lines
—An outdoor antenna should be located away from power lines. When installing an outside antenna system, extreme care should be taken to avoid
touching power lines or circuits, as contact with them may be fatal.
Outdoor Antenna Grounding
—If an outside antenna or cable system
is connected to these audio products, be sure the antenna or cable system is grounded
so as to provide some protection against voltage surges and built-up static charg-
es. Section 810 of the U.S. National Electrical Code, and Section 54 of the
Canadian Electrical Code, provide information with respect to proper grounding of
the mast and supporting structure, grounding of the lead-in wire to an antenna
discharge unit, size of grounding conductors, location of antenna-discharge unit,
connection to grounding electrodes, and requirements for the grounding electrode.
See the grounding diagram (right).
Overloading
—Do not overload wall outlets and extension cords, as this could
result in fire or electric shock.
Object and Liquid Entry
—Never insert objects of any kind through the
openings of these appliances, as they may touch dangerous voltage points or
short-out parts that could result in a fire or electric shock. Care should be taken so that
objects do not fall and liquids are not spilled into the appliance through openings in the enclosure.
Servicing
—Do not attempt to service these appliances yourself, as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all
servicing to qualified service personnel.
Damage Requiring Service
—These appliances should be serviced by qualified service personnel when:
• A power supply connection or a plug has been damaged or
• If liquid has been spilled into the appliance or objects have fallen into the appliance or
• The appliance has been exposed to water or moisture or
• The appliance does not appear to operate normally or exhibits a marked change in performance or
• The appliance has been dropped or the enclosure damaged.
Replacement Parts
—When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or that
have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock, or other hazards. The Master Control Unit battery should be
replaced only after turning the power off and only by an authorized installer.
Safety Check
—Upon completion of any service or repairs to this audio product, ask the service technician to perform safety checks to determine that the audio
product is in proper operating condition.
Lightning Storms
—Unplug this apparatus during lightning storms or when unused for long periods of time.
Attachments and Accessories
—Use only attachments/accessories specified by the manufacturer.
Cart, Stand, Tripod, Bracket or Table
—Use only with a cart, stand, tripod, bracket or table specified by the manufacturer, or sold with the apparatus.
When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip over.
Disconnect Device
—Where the mains plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain operable.
®
U S C
ELECTRIC
SERVICE
EQUIPMEN T
GROUND
CLAMPS
POWER SER VICE GROUNDING
ELECTRODE
SYSTEM
(CEC SECTION 10-700)
ANTENNA
LEAD-IN WIRE
GROUND CLAMPS
GROUNDING CONDUCTORS
(CEC SECTION 54-200)
ANTENNA LEAD-IN WIRE
(CEC SECTION 54-200)
NE C - NATIONAL ELECTRICAL CODE
(NEC SECTION 810-20)
(NEC SECTION 810-21)
(NEC AR TICLE 250, PA RT H)
CE C - CANADIAN ELECTRICAL CODE
Grounding
Diagram
®
U S C
®
U S C