Aquacal 110 - Manual (Page 32)

32
INSTALLATION INSTRUCTIONS (continued):
Electrical Requirements ------------------------------------------- 43
General Requirements ------------------------------------------ 43
Code-Specific Requirements ----------------------------------- 43
Connecting External Controllers -------------------------------- 43
Sizing the Electrical Service ------------------------------------ 44
Ground Fault Protection (not recommended) ------------------ 44
CONTROLS CONFIGURATION & ADJUSTMENTS ---------------------- 45
Level-2 (dealer-service) Programming ---------------------------- 45
1. Entering Service Menu --------------------------------------- 45
2. Time Delay --------------------------------------------------- 46
3. Configuring for External Controllers ------------------------- 46
4. Water Sensor Calibration ------------------------------------ 46
5. Defrost Sensor Calibration ----------------------------------- 47
6. Spa Dead Band Differential (and adjustment) -------------- 48
7. Pool Dead Band Differential (and adjustment) ------------- 48
8. Changing Service Lock Code & “Back Door” Entry ---------- 49
Level-2 Set Up & Calibration Codes ------------------------------- 50
Factory Default Settings ------------------------------------------- 50
Troubleshooting Using Displayed Codes -------------------------- 51
Mode Jumper and Positioning ------------------------------------- 52
Defrost Systems (described and explained) ---------------------- 54
Water Flow Pressure Switch Adjustment-------------------------- 55
CONTACTING THE FACTORY ------------------------------------------ 57
INSTALLER-SPECIFIC TABLE of CONTENTS
(CONTINUED)