Manufactured (mobile) home installation, Warning – Alliance Laundry Systems LES37A User Manual

Page 13

Advertising
background image

504607

11

Manufactured (Mobile) Home

Installation . . .

The dryer can be installed in a manufactured (mobile)
home by following these instructions:

1. IMPORTANT: Gas dryers MUST be

permanently attached to the floor at the time of
installation. Order No. 526P3 Dryer Installation
Kit for a manufactured (mobile) home
installation. Follow the instructions supplied
with the kit.

2. Electrical Connections (Electric Dryer Only) must

be a 4-wire connection, refer to page 13.

3. Venting—Dryer MUST be exhausted to the

outdoors.

• The dryer can be exhausted to the outdoors through

the back, left, right or bottom panel. Gas dryers
cannot be exhausted out the left side because of the
burner housing.

• The dryer exhaust duct must be secured to the

mobile home structure.

• Exhaust ducts MUST NOT be connected with sheet

metal screws or fasteners which extend into the duct.

• Exhaust duct must not be connected to any other

duct, vent or chimney.

• Dryer exhaust duct MUST NOT terminate under the

mobile home.

• For proper operation, it is important that the dryer

has an ample amount of outside make-up air. The
free area of any opening for the introduction of
outside air must be at least 25 in

2

(163 cm

2

).

• When exhausting the dryer to the outdoors, the dryer

can be installed with “0” inch clearance at the sides
and rear. Clearance of the duct from combustible
construction must be a minimum of 2 inches (5.08
cm).

• Venting materials are not supplied with the dryer

(obtain locally).

IMPORTANT: Installation must conform to
the Manufactured Home Construction and
Safety Standards, Title 24 CFR, Part 32-80 or
Standard CAN/CSA-Z240 MH.

To reduce the risk of fire and combustion
gas accumulation, the dryer MUST BE
EXHAUSTED TO THE OUTDOORS. Refer to
Section on Dryer Exhaust Requirements.

W047

WARNING

To reduce the risk of fire, the exhaust duct
and weather hood MUST be fabricated of a
material that will not support combustion.
Rigid or flexible metal pipe is recommended
for a clothes dryer.

W048

WARNING

Advertising
This manual is related to the following products: