Aruba Networks Access Point Aruba AP 60/61 - Manual (Page 38)

Troubleshooting
Appendix A
34 Aruba AP 60/61 0500160
Installation Guide December 2005
AP Support
Access Levels
z User Access
User access is a low security level, featuring only the most basic commands.
It is available without any additional login after the AP has booted.
z Privileged Access
Privileged-level access requires the privileged password (the same privileged
password used on the Mobility Controller) to be entered using the user level
enable command. The privileged access level is available only after the AP has
successfully booted and synchronized with Mobility Controller.
User Commands
z ping <host|IP address>
Verify IP connectivity between the AP and the host address.
z route
Display the contents of the AP route table.
z ifconfig
Display the AP’s IP address settings.
z enable <privileged password>
Access the AP Support privileged mode.
Privileged Commands
In addition to the user commands, the following commands are available upon
successfully entering the privileged mode:
z ps
z show [config|stats|version]
N OTE : These commands should be used only as directed by Aruba
Customer Support.