Asus AP3000 - Manual (Page 35)

35
IV. Hardware Setup
IV
. Hardware Setup
AP 3000 Hardware Reference Guide
• 4-14. SCSI Termination
Female Terminator for SCSI cable Male Terminator for SCSI Board
• 4-15. Power Supply
Power Supply Mounting
Mounting and unmounting the power supply must be done from the
inside. Four screws are used to secure the power supply to the chassis
back side.
SCSI/Power
Terminating the SCSI bus “chain” is necessary for SCSI devices to work
properly. Ultra2 devices do not have termination jumpers and must be ter-
minated using a terminator on the SCSI cable which means you cannot
connect a device on the last connector.