Alpine TDM-7581R - Manual (Page 23)

21
-EN
Installation
1
Remove the Detachable Front Panel (refer to
page 4). Slide mounting sleeve from main unit.
(See Removal Procedure) Slide the mounting
sleeve into the dashboard.
2
When your vehicle has the Bracket, mount the
long hex bolt onto the rear panel of the TDM-
7583R/TDM-7581R/TDM-7580R and put the
Rubber Cap on the hex bolt. If your vehicle does
not have the Mounting Support, reinforce the
head unit with the metal mounting strap (not
supplied). Connect all the leads of the TDM-
7583R/TDM-7581R/TDM-7580R according to
details described in the CONNECTIONS section.
NOTE:
For the screw *, provide a proper screw to the chassis
installing location.
3
Slide the TDM-7583R/TDM-7581R/TDM-7580R
into the dashboard. When the unit is in place,
make sure the locking pins are fully seated in the
down position. This can be done by pressing
firmly in on the unit while pushing the locking pin
down with a small screwdriver. This ensures that
the unit is properly locked and will not
accidentally come out from the dashboard. Install
the Detachable Front Panel.
Lock pin
Removal
1 Remove the detachable front panel.
2 Use a small screwdriver (or similar tool) to push the
locking pins to the "up" position (see above drawing).
As each pin is unlocked, gently pull out on the unit to
make sure it does not re-lock before unlocking the
second pin.
3 Pull the unit out, keeping it unlocked as you do so.
<JAPANESE CAR>
Face Plate
Mounting Bracket
Metal Mounting Strap
Screw
Bolt Stud
Hex Nut
(M5)
∗
Bracket
Mounting Sleeve
(Included)
TDM-7583R/TDM-7581R/
TDM-7580R
Dashboard
Rubber Cap
(Included)
Hex Bolt
(Included)
TDM-7583R/TDM-7581R/
TDM-7580R
Screws (M5
×
8)
(Included)
TDM-7583R/TDM-7581R/
TDM-7580R