Alpine TDM-7581R User Manual
Page 25
23
-EN
1
Antenna Receptacle
Connect to the supplied ISO antenna convertor
plug.
2
Audio Interrupt In Lead (Pink/Black)
Connect this lead to the Audio Interface output of
a cellular phone which provides ground shorting
when a call is received.
3
Remote Turn-On Lead (Blue/White)
Connect this lead to the remote turn-on lead of
your amplifier or signal processor.
4
Power Antenna Lead (Blue)
Connect this lead to the +B terminal of your
power antenna, if applicable.
NOTE
This lead should be used only for controlling the
vehicle's power antenna. Do not use this lead to turn on
an amplifier or a signal processor, etc.
5
Switched Power Lead (Ignition) (Red)
Connect this lead to an open terminal on the
vehicle's fuse box or another unused power
source which provides (+) 12V only when the
ignition is turned on or in the accessory position.
6
Fuse Holder (15A)
7
Battery Lead (Yellow)
Connect this lead to the positive (+) post of the
vehicle's battery.
8
ISO Power Supply Connector
9
Ground Lead (Black)
Connect this lead to a good chassis ground on
the vehicle. Make sure the connection is made to
bare metal and is securely fastened using the
sheet metal screw provided.
!
Remote Control Interface Connector
(TDM-7583R only)
To remote control interface box.
"
Rear Output RCA Connectors
RED is right and WHITE is left.
#
DIN Connector
Connect this to the DIN connector on the CD
Changer.
$
DIN Extension Cable
NOTE
Older Alpine CD Changer came with standard, straight
type DIN connectors. In installations where an L-type
connector would simplify installation, the Alpine 4910
02
Adaptor can be used (Sold Separately).
%
Power Supply Connector
&
ISO Connector (Speaker Output)
(
Left Rear (+) Speaker Output Lead (Green)
)
Left Rear (–) Speaker Output Lead (Green/
Black)
~
Left Front (+) Speaker Output Lead (White)
+
Left Front (–) Speaker Output Lead (White/
Black)
,
Right Front (–) Speaker Output Lead (Grey/
Black)
-
Right Front (+) Speaker Output Lead (Grey)
.
Right Rear (–) Speaker Output Lead (Violet/
Black)
/
Right Rear (+) Speaker Output Lead (Violet)
:
RCA Extension Cable (Sold Separately)
To prevent external noise from entering the audio system.
• Locate the unit and route the leads at least 10cm away from the car harness.
• Keep the battery power leads as far away from other leads as possible.
• Connect the ground lead securely to a bare metal spot (remove the coating if necessary) of the car
chassis.
• If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine
dealer carries various Alpine noise suppressors, contact them for further information.
• Your Alpine dealer knows best about noise prevention measures so consult your dealer for further
information.