ATTO Technology FC-44ES - Manual (Page 33)

29
Supplemental Guide for VMware ESX/ESXi
The following information should be used by advanced users only. Please consult with our Technical Support
Department before applying any of the following information.
1 Driver Configuration
Use the esxcfg-module command to query and
configure the ATTO adapter driver parameters. In
the examples that follow, <driver name> should be
replaced with the ATTO driver name.
To obtain a list of available driver parameters:
# esxcfg-module -i <driver name>
To list the driver parameters that have been set:
# esxcfg-module -g <driver name>
To set a driver parameter:
# esxcfg-module -s param=value <driver name>
Configuration changes made with the esxcfg-
module -s command are persistent across system
reboots. However, the changes will not take affect
until the system is rebooted.
The following table lists the configurable parameters along with a brief description. Supported driver
abbreviations are: A - All drivers, C - celerityfc, celerity8fc, E - esashba, esas2hba.
PARAMETER DESCRIPTION
Driver
Support
atto_log_mask Defines the log mask for sending ATTO driver
information to the system log. Default is 0 (none). A
atto_max_sectors Maximum number of disk sectors in a single data
transfer. Default is 65535 (largest possible value). A
can_queue Maximum number of commands per adapter
channel. Default is 128. A
change_notification Enable notifying the OS of the arrival and departure
of target devices. Default is 1 (on). A
cmd_per_lun Maximum number of commands per LUN. Default
is 16. A
cmd_retry_count Maximum number of retries allowed for a
command. Default is 20. A
event_log_mask A bit mask of events to report to the system log.
Default is 0x00000001 (crtitical events only). A
fab_alternate_exchanges Causes the chip to alternate between to exchanges
when it runs out of credits on a fabric. This may
improve performance in multiple initiator/target
environments. Default is 0 (off). C
heap_initial Initial heap size allocated for the dirver. A
heap_max Maximum attainable heap size of the driver. A
io_time_out Time (in seconds) before an I/O command is timed
out by the driver. Set to 0 for no timeout. Default is
30. A
max_logins Defines the maximum number of ports that can be
logged in at once. Default is 256. C