ATTO Technology FC-44ES - Manual (Page 34)

30 ATTO Technology Inc. Celerity FC Host Adapters Installation and Operation Manual
num_erq Exchange Request Queue entries. In general, one
ERQ entry is required for each SEST entry. Default
is 256. C
num_imq Incoming Message Queue entries. These are used
to report completion of I/O requests and to notify
the host driver of certain other kinds of events
detected by the hardware. Default is 256. C
num_sas_addr Number of SAS addresses to assign to the
adapter’s PHYs. Addresses are assigned
sequentially from the base address. Valid settings
are 1, 2, 4, 8. Default is 1. E
num_sest Number of entries in the SCSI Exchange State
Table. One of these structures is used per active
exhance. Default is 256. C
num_sg_lists Number of SGL pages. Default is 256. A
num_targets Maximum number of target devices. Default is 256. E
old_device_reset Use the old device reset method. Default is 0 (use
new method). A
port_retry_count Maximum number of retries allowed for a port
which is logged out. Default 0 (use NVRAM
setting). C
private_els_timeout Timeout (in seconds) for ELS commands when on
a private loop. Default is 2. C
quick_init Enabled quick link initialization. Default is 1
(enabled). C
sg_tablesize Maximum number of entries in a scatter/gather
table. A value of 255 means that the S/G table be
any size. Default is 255. A
sgl_page_size Scatter/Gather List page size in number of S/G
entries. Default is 128. A
speed_override Override the NVRAM link speed setting. 0 for auto
speed negotiation, 2 for 2Gb, 4 for 4Gb or 8 for
8Gb. Other values will cause the use of NVRAM
setting. Default is -1 (use NVRAM setting) C
topology_override Override the NVRAM topology setting. 0 for loop, 1
for PTP, 2 for loop preferred, 3 for PTP preferred.
Other values will cause the use of NVRAM setting.
Default is -1 (use NVRAM setting). C
use_tm_completions Wait for task management commands to complete
before returning from handler. Default is 1
(enabled). A
use_transport_layer Attached to the SCSI transport layer. Default is 1
(enabled). A