Avaya VF 3000 - Manual (Page 35)

6.1.4. Configure the Juniper VF 3000 SBC
The following section describes how to configure the Juniper VF 3000 SBC for LSP enterprise
sites. Only the Signaling Card (SC) needs to be updated, not the Media Card (MC). In a High
Reliability (HA) configuration, both the master and backup (SC) needs to be updated. This
document assumes that Juniper VF 3000 SBC basic provisioning has been performed. Refer to
[2] for more information. The steps below are for enterprise site A1.
Connect to the (SC) interface of the Juniper VF 3000 SBC via the console port or telnet to the
management interface, which should already be administered.
Step 1. Enter “privileged” mode to input configuration and management commands. Enter the
“privilege” mode password. Enter command blade session-routing Æ then sr-policy (policy to
be modified) then option Æ and then lsp-address <IP address> to add the Native LSP IP
address to the sr-policy defined for enterprise site A1 as shown in Figure 26.
Figure 26
TC; Reviewed:
PV 04/24/2006 Avaya – Proprietary
Use as authorized only pursuant to your signed agreement or
Avaya policy. No other disclosure is permitted or authorized.
35 of 61
HT3-LSP-VF.doc