Document Outline

• About This Chapter
• Scope of the Manual
  • BU-DS.11 Wireless Base Unit
    • RB-DS.11 Wireless Bridge
  • BreezeNET DS.11 Compatibility and Standards
    • About This Chapter
• Packing List
• Additional Installation Requirements
• Installation Overview
• Outdoor Installation Considerations
  • Collocating DS.11 Outdoor Units
  • Site Selection Factors
    • Path of Clearest Propagation
    • Physical Obstacles
    • Path Loss
  • Rooftop Installation
  • Antennas for Outdoor Applications
    • Point-to-Point
    • Point-to-Multipoint
  • Antenna Polarization
  • Antenna Seal
  • Cell Size/Link Distance
  • Using Outdoor Range Tables
  • Available Antennas
  • Precautions
  • Compliance with Radio Regulations
• Installing the Outdoor Unit
  • Connecting the Ground and Antenna Cables
  • Connecting the Indoor-to-Outdoor Cable
• Installing the Indoor Unit
  • Configuring Parameters
  • Antenna Alignment
• Verifying Correct Operation
  • Verifying Correct Operation of the Indoor Unit
  • Verifying Correct Operation of the Outdoor Unit
  • What to do if the Self Test Fails
    • About This Chapter
• Installing and Accessing the Configuration Utility
• Configuration Utility Modes
  • Unit Configuration Mode
    • Control Window
    • Tabs Section
    • Control Window
      • Selecting Units
      • Setting the SNMP Community String
      • Assigning and Editing IP Addresses Manually (based on MAC ad
    • Application Control Buttons
    • Configuration Utility Tabs
      • Station Status Tab
      • Networking Parameters Tab
        • Networking Parameters-General Tab
        • IP Parameters
        • DHCP
        • VLAN Support
        • Networking Parameters-CPE Table Tab (BU only)
      • SNMP Parameters Tab
      • Counters Tab
      • WLAN Parameters Tab
      • Station Control Tab
      • Security Tab
        • Encryption Tab
      • ACL Table Tab (BU only)
      • Advanced Tab
      • General Parameters Tab
      • Auto-Config Tab
      • Trap Monitor Tab
  • Firmware Upgrade Mode
    • Advanced TFTP Settings
  • Multiple Unit Configuration Mode
• Resetting the SNMP Community Strings
• Reloading Factory Default Settings
  • About This Chapter
• Configuring Critical Parameters
  • One-Click Configuration
  • Short Preamble
  • CW Minimum
  • RTS Threshold
  • Basic Rate
  • Range
    • About This Chapter
• Troubleshooting Guide
  • Supported Standards
    • Configuration and Management
      • Radio
      • Range
      • Security
      • Outdoor Unit-to-Indoor Unit Communication
      • Interfaces
      • Electrical
      • Mechanical Dimensions
      • Environmental
      • Standards Compliance, General
• General
• Collocation and Interference
• Firmware
• Configuration
• Accessories
• Management
  • RF Terms and Definitions
    • dB
    • RF Power Level
    • Attenuation
    • Path Loss
    • Free Space Loss
    • Antenna Characteristics
      • Isotropic Antenna
      • Antenna Gain
      • Radiation Pattern
      • Side Lobes
      • Omni-directional Antenna
      • Directional Antenna
      • Antenna Beamwidth
    • System Characteristics
      • Receiver Sensitivity
      • EIRP (Effective Isotropic Radiated Power)
      • Link Parameters
      • Link Budget Calculation
      • Signal Fading
    • The Line of Sight Concept
      • Clear Line of Sight
      • Fresnel Zone