HP Laserjet 1200 - Manual (Page 171)

EN Understanding the print server configuration page 169
General HP JetDirect information
Message Description
Status The current state of the print server:
I/O Card Ready: The print server has successfully connected
to the network and is waiting for data.
I/O Card Initializing: The print server is initializing the
network protocols. See the status line for each protocol on the
configuration page for more information.
I/O Card Not Ready: There is a problem with the print server
or its configuration.
Note
If the print server is not ready, an error code and message
appears. See
Error messages .
Model Number The HP JetDirect print server’s model number (for example,
J6035A).
Hardware Address The 12-digit hexadecimal network hardware (MAC) address of
the print server that is installed in the printer or device. The
manufacturer assigns this address.
Firmware Version The firmware revision number of the print server that is
currently installed in the printer. The format is X.NN.NN,
where X is a letter that depends on the HP JetDirect print
server model.
Port Select The LAN port on the print server that has been detected for
use:
None: The print server is not connected to the network.
RJ-45: The RJ-45 network port is connected.
Port Config The link configuration of the RJ-45 LAN port on the print
server:
10BASE-T HALF: 10 Mbps, half-duplex
10BASE-T FULL: 10 Mbps, full-duplex
100TX HALF: 100 Mbps, half-duplex
100TX FULL: 100 Mbps, full-duplex
Unknown: The print server is in an initialization state.
Disconnected: A network connection has not been detected.
Check the network cables.