HP Laserjet 1200 - Manual (Page 160)

158 Chapter 10 Troubleshooting the copier/scanner EN
Replacing the copier/scanner separation pad
If your copier/scanner input tray feeds
more than one page at a time, you might
need to change the copier/scanner
separation pad. Recurring problems
indicate that the copier/scanner
separation pad is worn. See
Accessories
and ordering information to order a new
copier/scanner separation pad.
1 To open the copier/scanner door,
press the release button.
2 Grasp the separation pad and mylar
sheet firmly between your thumb
and index finger, and pull them
straight up and out.
Note
You will feel resistance because the tabs
attach the black pad holder to the
copier/scanner. This is normal. The pad
holder is part of the replacement unit. It
is also released by your action.
3 Snap the new pad holder, with the
separation pad and mylar attached,
into position.
4 Close the copier/scanner door.
1
2
3
4