ATTO Technology 1550D - Manual (Page 27)

23
ATTO Technology Inc. iPBridge Installation and Operation Manual
6 Updating Firmware
Several processors control the flow of data in the ATTO iPBridge. The firmware to control these processors can
easily be upgraded in the field.
The iPBridge firmware is distributed as an .ima file can
be obtained from the ATTO Technology, Inc. web site
at
www.attotech.com or from the CD included with
your iPBridge.
CAUTION CAUTION
Before beginning this procedure, ensure
that all I/O to the iPBridge has stopped.
During this procedure, do not interrupt the
flash process.
Do not power down the host or the
iPBridge until the display returns the
Ready prompt.
Interrupting the flash process will make
your iPBridge inoperable and you must
return it to ATTO Technology for repair.
Using ATTO ExpressNAV
1 If you have not already, open an ExpressNAV
session. For instructions, refer to
Opening an
ExpressNAV session on page 25 .
2 Click on the Firmware page.
3 Click Browse and locate the firmware you
downloaded from the website or from the CD.
A sample filename:
c:\bridge_firmware\ibrg0370.ima
4
Click Upload and wait until a success message
is displayed.
5 Click the Restart link.
6 Click on Restart.
Using FTP
1 Establish an FTP link to the bridge that is to be
flashed.
2 Use the PUT command to download the
firmware file. A sample filename:
c:\bridge_firmware\ibrg0370.ima
3
Once the download is complete, cycle power on
the iPBridge to activate the new firmware.