ATTO Technology 1550D - Manual (Page 38)

ix
ATTO Technology Inc. iPBridge Installation and Operation Manual
iSCSIVideoStreaming
This command is used to set the iSCSI video streaming
mode. Enable video streaming mode if RX FIFO
overflows are being reported in the event log. Enabling
this mode may signficiantly degrade write performance.
Default: disabled
set iSCSIVideoStreaming [enabled | disabled]
get iSCSIVideoStreaming
iSCSIWANIPAddress
Sets or displays the IP address reported to an iSCSI
initiator located outside the iPBridge LAN. If this iPBridge
is behind a NAT router, the address must be set to the
external IP address of the router. Setting the address to
0.0.0.0 causes the iPBridge to be inaccessible from
outside the LAN.
Default: 0.0.0.0
set iSCSIWANIPAddress [dp1] | all] [xxx.xxx.xxx.xxx]
get iSCSIWANIPAddress [dp1] | all]
iSNSLoginControl
Specifies whether the iPBridge delegates its access
control/authorization policy to an iSNS server.
Note
iSNSLoginControl cannot be used with
AccessControl .
Default: disabled
set iSNSLoginControl [enabled | disabled]
get iSNSLoginControl
iSNSServer
Specifies the IP address of a valid iSNS server from
which the iPBridge tries iSCSI initiator discovery. Set to
0.0.0.0 to disable iSNS server lookup.If
VLAN is
enabled, a VLAN ID must be specified for each data port.
All iSNS connections have the same VLAN tag.
Default: 0.0.0.0
set iSNSServer [xxx.xxx.xxx.xxx] <[dp1] [VLAN ID]>
get iSNSServer
IsReserved
Displays the reservation status of the current iPBridge.
IsReserved
Password
Specifies the password used for all sessions: NDMP,
Telnet, FTP and ExpressNAV. Password is case
sensitive, 0 to 32 characters, and cannot contain spaces.
An empty password can be configured by pressing the
enter key when prompted for the new password and new
password confirmation.
Default: Password
set Password
Ping
Sends an ICMP echo request to the specified host.If
VLAN is enabled, the VLAN ID must be provided.
ping [dp1] [xxx.xxx.xxx.xxx] <VLAN ID> <count <size>>
ReadOnlyPassword
Specifies a password which allows only read and no
writes. It is case sensitive, 0 to 32 characters, and cannot
contain spaces. An empty password can be configured by
not specifying one.
Default: Password
set ReadOnlyPassword
ReadOnlyUsername
Specifies the user name which allows only read and no
writes. It is case insensitive, 1 to 32 characters, and
cannot contain spaces.
Default: user
set ReadOnlyUsername [username]
get ReadOnlyUsername
Reserve
Reports the state of CLI reservation for the current CLI
session. If the command reports that Reservations are
enabled, then another CLI session has control of
parameter modification on the unit.
Reserve
RestoreConfiguration
Issued with the default option, forces the iPBridge
NVRAM settings to their original defaults. The saved
option undoes any changes made to this session since
the last save.
RestoreConfiguration [Default | Saved]