Aviom A-16II - Manual (Page 25)

17
• The S
OLO
button has one LED. It will light when pressed,
indicating that the selected Channel or Group is now being
auditioned with all other Channels being muted. Two Solo
modes are available.
• The M
UTE
button has no LED in it. Pressing the M
UTE
but-
ton with a Channel selected will cause the Channel’s lower
(yellow) LED to light.
There is also one special button combination, the R
ECALL
button followed
by the M
UTE
button. When used together this combination serves a twofold
function:
• If there is a sudden change in the audio volume coming
through the monitor system, this button combination
silences all audio channels instantly.
• When starting from scratch to create a mix, use this func-
tion to set all sixteen channels to zero volume and all pans to
the center settings.
A-16
Save
Recall
1 2
Group Solo Mute
Select
Mute
In Recall
Mode All
Volumes
Zero
3 4 5 6 7 8 9 10 11 12 13 14 15 16
All Volumes Zero
Note: The text on the right side of the Personal Mixer label reads “In
Recall Mode All Volumes Zero ” as a reminder that this function is
always available.
Basic Navigation
When the system is powered up, Preset 1 is automatically selected. On the
Personal Mixer, one Channel is always selected for editing. You can tell that
a Channel is selected because the upper LED in its button is lit.
The sixteen Channel buttons have two LEDs in each, an upper and a lower.
The red upper LED indicates that the Channel is selected; you can change
its volume and panning. You can also solo or mute the channel using the
dedicated S
OLO
and M
UTE
buttons on the Personal Mixer surface.
The upper LEDs will also light in combination if a track is linked or is part
of one of the three available Groups. (More info on Groups appears later in
this document.)