Aastra Telecom 9133i (INSTALLATION GUIDE) - Manual (Page 8)

5 Model 9133i Installation Guide
Installation and Setup
Installation and Setup
The 9133i can be setup to share a network connection with another network
device. Power can be provided by an 802.3af compliant network power
source or with a PoE inline power supply (optional accessory). It can also be
installed on a desk or mounted on the wall. If your System Administrator has
already setup your phone, please refer to the (if provided) for call handling
information or talk to your System Administrator.
Direct or Shared Network Connection
The phone can be set up as a direct network connection to the Ethernet wall
jack or as a shared network connection as a pass-through if connecting the
phone to a computer or another network device.
Direct Network Connection
Located at the back of the phone
are two fully switched 10/100
Mbps Ethernet cable ports. The
port marked with
l is used to
connect the phone to the
network, as well as provide
power to your phone. See the
section “Connecting to the
Network and to Power” on
page 6
for more information.
Shared Network Connection
To connect a network device
(such as a computer) to the
phone, connect an Ethernet Cable
into the network port on the back
of the phone marked with
;.
Plug the other end of the
Ethernet Cable into the network
jack on the network device you
are sharing the network
connection with.
Note: The
;
jack on the 9133i does not supply inline power onto other network devices.
All Ethernet cables used must be category 5/5e straight-through cables, such as
the cable provided with your phone
Ethernet
Cable
Network Jack
(if Inline power provided)
To Network
Other Network Devices
Separate
Network
Jack
Ethernet
Cable
Network Jack
(if Inline power provided)
To Network
Other Network Devices
To Other
Network Device