HP Latex 360 Printer - Manual (Page 54)

8. The right stop of the 76 mm (3 in) diameter spindle has two positions: one for rolls of the printer's
maximum width, and another for narrower rolls. Remember to use the second position for narrower
rolls, which improves the curing process and allows higher printing speeds.
NOTE: The 76 mm (3 in) diameter spindle is supplied with the 360 printer and is available as an
accessory for the 330 printer.
NOTE: The 51 mm (2 in) diameter spindle supplied with the 310 and 330 printers has only one position
for the right stop. There are blue lines on the loading table corresponding to two positions, but when
using this spindle you can use only the outer position.
9. Put the blue stop on to the upper end of the spindle, and push it towards the end of the roll.
48 Chapter 3 Handle the substrate and troubleshoot substrate issues ENWW