HP Photosmart C4380 All-in-One Printer - Manual (Page 164)

Prepare the HP All-in-One for shipment
If after contacting HP Support or returning to the point of purchase you are requested to send the
HP All-in-One in for service, make sure you remove and keep the following items before returning
your device:
• The print cartridges
• The power cord, USB cable, and any other cable connected to the HP All-in-One
• Any paper loaded in the input tray
• Any originals loaded in the HP All-in-One
To remove print cartridges before shipment
1. Turn on the HP All-in-One and wait until the print carriage is idle and silent. If the HP All-in-One
will not turn on, skip this step and go to step 2.
2. Open the print cartridge door.
3. Remove the print cartridges from their slots.
NOTE: If the HP All-in-One does not turn on, you can unplug the power cord and then
manually slide the print carriage to the far right side to remove the print cartridges.
4. Place the print cartridges in an airtight plastic container so they will not dry out, and put them
aside. Do not send them with the HP All-in-One unless the HP customer support call agent
instructs you to.
5. Close the print cartridge door and wait a few minutes for the print carriage to move back to its
home position (on the left side).
NOTE: Make sure the scanner is idle and has returned to its parked position before turning
off the HP All-in-One.
6. Press the On button to turn off the HP All-in-One.
Pack the HP All-in-One
Complete the following steps once you have removed the print cartridges, turned off the HP All-in-
One, and unplugged it.
To pack the HP All-in-One
1. If available, pack the HP All-in-One for shipment by using the original packing materials or the
packaging materials that came with your exchange device.
Prepare the HP All-in-One for shipment 163
HP w
a
rranty
and
sup
port