HP StorageWorks XP Remote Web Console Software - Manual (Page 36)

36 Auto LUN XP for the XP128/XP1024
The migration logs may display the following messages:
Troubleshooting Auto LUN XP
Auto LUN XP displays error messages in Command View XP or XP Remote Web Console when error
conditions occur during Auto LUN XP operations.
If you need to contact your HP account support representative, provide as much information about the
problem as possible, including the error codes.
Log entry that the auto migration plan could not be made:
Cannot make plan: Class X Grp X-X
(a) (b)
(a) Class
(b) Parity group
Some monitor data samples were invalidated:
Grp X-X: X samples are invalidated because of migration.
New volumes have been installed:
New entries are added for following LDEVs: CU:LDEV, CU:LDEV, ...
Invalid data:
Too many invalid data: invalidated all data
Volume utilization check failed:
Utilization check failed
Check volume usage failed because the necessary data could not be obtained. Please get
the data again.
Volume reserve attribute check failed:
Reserve volume check failed
Check volume reserve attribute failed because the necessary data could not be obtained.
Please get the data again.
Table 9 Migration log messages
Message Meaning
Migration Start
Migration operation started
Migration Complete
Migration operation completed successfully
Migration Cancel
User canceled the migration operation
Migration Failed
Migration operation failed
Migration Give Up
Migration operation was canceled by Auto LUN XP (for example, volume usage rate
exceeded specified maximum)