HP 1.10GB Virtual Connect Ethernet Module for c-Class BladeSystem User Manual

Page 112

Advertising
background image

Virtual Connect fabrics 112

NOTE:

If using a Brocade FC switch, verify that NPIV is enabled properly by using the

portshow command. If NPIV is not enabled properly, you might need to downgrade the

Brocade switch firmware, and then upgrade the firmware again.

For VC 8Gb 24-Port FC Modules, if uplink port 8 is present in the VC SAN fabric definition, this port is treated

as the lowest-numbered port and receives server logins before any other uplink ports.

•

Single enclosure domain

Advertising
This manual is related to the following products:

Virtual Connect 4Gb Fibre Channel Module for c-Class BladeSystem, Virtual Connect FlexFabric 10Gb24-port Module for c-Class BladeSystem, Virtual Connect 8Gb 20-port Fibre Channel Module for c-Class BladeSystem, Virtual Connect 8Gb 24-port Fibre Channel Module for c-Class BladeSystem, 4GB Virtual Connect Fibre Channel Module for c-Class BladeSystem, Virtual Connect Flex-10 10Gb Ethernet Module for c-Class BladeSystem

Popular Brands
Popular manuals