HP 3PAR Operating System Software - Manual (Page 45)

3PAR InForm Management Console 4.1.0 User’s Guide
320-200231 Rev A 45
Configuring Interface, Dialog, and Tab Settings
To configure interface and dialog settings:
1. Select the Settings tab on the Preferences dialog box.
2. Select the user interface elements and dialog boxes you wish to view in the InForm
Management Console Interface by selecting the appropriate checKiBoxes.
3. Select whether to view Introduction tabs by clicking Remove All Tabs or Restore All
Tabs.
4. Click Apply to continue modifying preferences, or click OK when finished.
Setting Advanced Display Options
To set advanced display options:
1. Select the Advanced tab on the Preferences dialog box.
2. Select whether to view the Port State of loss sync as failed.
3. Select whether to view physical disk spares, advanced volume properties, logical disks,
and SCSI reservations by selecting the appropriate checKiBoxes.
4. Click Apply to continue modifying preferences, or click OK when finished.
Setting Per Table References
The InForm Management Console allows you to set per-table preferences. These
preferences are saved on the system and remembered the next time you log in using the
InForm Management Console.
Note: The per-table preferences and changes made by manually dragging
and sorting tables override any preferences specified when Setting Global
Preferences .
This topic provides procedures for the following:
Column Resizing
Column Ordering
Column Visibility
Choosing Columns
Table View