HP TouchSmart IQ775 Desktop PC - Manual (Page 51)

Upgrading the HP TouchSmart PC 47
Removing the rear cover
This procedure is necessary when removing and upgrading memory.
1 See “Opening and Closing the HP TouchSmart PC” on page 45.
2 Remove the two screws that secure the rear cover to the HP TouchSmart PC chassis. Keep the screws
for later.
3 Pull the rear cover back about 1/2 in (1.27 cm) (A). If necessary, gently push down on the cover while
pulling back.
4 Lift the rear cover and remove from the chassis (B).
WARNING: Beware of sharp edges inside the chassis.
+
-