HP TouchSmart IQ775 Desktop PC - Manual (Page 52)

48 HP TouchSmart PC User Guide
Replacing the rear cover
1 Place the rear cover in the proper position on the chassis and about 1/2 in (1.27 cm) back from the
vertical cover.
2 Slide the rear cover toward the front of the chassis until the rear of the cover is flush with the rear I/O
area of the chassis.
3 Ensure that the holes for the screws align with the holes in the chassis, and then replace the two
screws.
Removing the vertical cover
This procedure is necessary when removing or replacing the hard disk drive.
1 See “Opening and Closing the HP TouchSmart PC” on page 45.
2 If necessary, raise the display (monitor) until the pocket behind the monitor is accessible.
3 While holding the back of the vertical cover, push and hold down the lever on the front of the vertical
cover. This lever is located in a pocket behind the display (monitor) portion of the HP TouchSmart PC.
4 While holding down the lever, pull the vertical cover up and remove from the chassis.
CAUTION: To reduce the risk of personal injury from electrical shock or hot surfaces, disconnect
the power cord from the wall outlet, and allow the internal system components to cool before
touching.
Lever