HP Designjet T2500 eMultifunction Printer series - Manual (Page 50)

Menu item Sub-menu item Sub-menu item Values and Description
DHCP Renew This menu appears if Config Method was set to DHCP and
a DHCP lease for the print server exists.
No (default): The print server does not request to renew
the DHCP lease.
Yes : The print server requests to renew the current DHCP
lease.
Manual Settings (Available only if Config Method is set to Manual )
Configure parameters directly from the printer control
panel:
IP Address : The unique IP address of the printer (n.n.n.n).
Subnet Mask : The subnet mask for the printer (n.n.n.n).
Syslog Server : The IP address of the syslog server
(n.n.n.n) used to receive and log syslog messages.
Default Gateway : The IP address (n.n.n.n) of the gateway
or router used for communications with other networks.
Idle Timeout : The time period, in seconds, after which an
idle TCP print data connection is closed (default is 270
seconds, 0 disables the timeout).
Default IP Specify the IP address to default to when the print server
is unable to obtain an IP address from the network during
a forced TCP/IP reconfiguration (for example, when
manually configured to use BootP or DHCP).
Auto IP : A link-local IP address 169.254.x.x is set.
Legacy : The address 192.0.0.192 is set, consistent with
older HP Jetdirect devices.
Primary DNS Specify the IP address (n.n.n.n) of a Primary DNS Server.
NOTE: This item appears only if Manual configuration is
a higher priority than DHCP in the Config. Precedence
table, configured through the embedded Web server.
Secondary DNS Specify the IP address (n.n.n.n) of a Secondary Domain
Name System (DNS) Server.
NOTE: This item will appear only if Manual
configuration is a higher priority than DHCP in the Config.
Precedence table, configured through the embedded
Web server.
IPV6 Settings Enable Use this item to enable or disable IPv6 operation on the
print server.
Off : IPv6 is disabled.
On (default) : IPv6 is enabled.
Address Use this item to manually configure an IPv6 address.
Manual Settings : Use the Manual Settings menu to enable
and manually configure a TCP/ IPv6 address.
Enable : Select this item and choose On to enable manual
configuration, or Off to disable manual configuration.
Address : Use this item to type a 32 hexadecimal digit IPv6
node address that uses the colon hexadecimal syntax.
40 Chapter 4 Network configuration ENWW