AMX MAX-CSE - Manual (Page 72)

Displaying Stream Content
66 MAX-CSE/MAX-CSD10 Operation/Reference Guide
8. From the Profile field, click on the drop-down arrow and from the available list, choose the desired
encoder setting which conforms to the available data throughput on your network. Although the
default selection is Home Theater (Max), the user can choose from up to 6 pre-created entries and
one Custom entry which makes every field user-definable.
For the purpose of these procedures, we’ve been informed that our network can handle the full
6 Mbps data throughput, so we’ll select Home Theater (Max).
9. Click the Apply button to save the encoding profiles to the MAX.
10. From the Stream section of the page, locate the Transport Protocol field and use the drop-down
arrow to select a desired protocol. For the purposes of these procedures, select UDP as the protocol.
An UDP protocol is typically used with higher-bandwidth streams and only requires the entry
of a single Target Port because both the video and audio are combined into a single media
stream. With this method, the Modero panel always utilizes an audio port value of two greater
than that used by the Target Port.
An RTP protocol is typically used both with lower-bandwidth streams and when user wants to
purposely separate the video and audio information into two distinct streams. With this
method, the Target Audio Port must be manually entered and cannot be the same value as the
Target Port used for video.
11. Enter the previously obtained IP Address of the target Modero panel (FIG. 41) into the Target
Address field.
FIG. 42 Stream Profiles page