HP Integrity NonStop H-Series - Manual (Page 82)

earlier Search matches the last volume.subvolume pattern, then it is also selected to
notify you that it satisfies the last search criteria. There will not be duplicate
subvolumes in the table. You can remove subvolumes by selecting them in the table
and clicking the Remove button.
— At least one subvolume must be selected before you can click the Submit button. All
subvolumes that are selected when Submit is clicked will be used to receive software
into one package.
• The Scheduling tab allows you to schedule the receive software request “Now” or “Later.”
If “Now” is selected, the request begins as soon as the Submit button is clicked. If “Later”
is selected, you must enter a date and time; the request will begin based on the server's
system clock. If the time specified is in the past, the request begins immediately.
Figure 6-3 Scheduling Tab
4. After making any desired changes to the fields in all three tabs, click the Submit button to
initiate the Receive Software Request. Upon doing so, the Request Status page is loaded into
the work panel, allowing you to
check the status of the request .
Check the Status of the Request
Upon submitting the Receive Software Request, a Request Status page is loaded into the work
panel, displaying the status for that Receive Software Request.
NOTE: If closed prematurely, that Request Status Page can be also be accessed by clicking on
the individual request name on the Request List Page, which can be launched either from the
Requests menu on Menu bar or the Show Requests link on the NonStop Software Essentials Home
page.
To check the EMS event messages, from the Request Status Page, click on a system name in the
System column. The number in quotes is the EMS message number. If you receive an error, see
the DSM/SCM Messages Manual for cause, effect, and recovery information. For troubleshooting,
see
“Software Configuration Troubleshooting” (page 185) .
NOTE: If you are installing a SUT, check the EMS messages to see if a new cartridge on a
nonautoloading drive of the RVU needs to be mounted.
Once the software package has been successfully received, the next step in the software upgrade
process is to create a new software revision, as described in
Chapter 7: “Creating and Managing
Software Revisions” .
82 Receiving and Managing Software Packages