HP ProLiant DL740 Server - Manual (Page 265)

Troubleshooting Information
Table E-7: Problems After Initial Boot continued
Problem Possible Cause Possible Solution
Required operating system step
was missed. Follow these steps:
1. Note at which phase the operating
system failed.
2. Remove any loaded operating
system.
3. Refer to your operating system
documentation.
4. Reinstall the operating system.
Installation problem occurred. Refer to your operating system
documentation and to the SmartStart
Release Notes on the SmartStart CD.
Use the ROM-Based Setup Utility to
troubleshoot where the installation
failed.
Server cannot load
the operating
system
Problem was encountered with
the hardware that you added to
the system. Refer to the documentation provided
with the hardware.
Run the ROM-Based Setup Utility to
determine if drives are properly attached
to the primary boot controller. Refer to
Chapter 6 for instructions about the
correct SCSI bus-cabling configuration
for your unit.
E-14 HP ProLiant DL740 Server User Guide
HP CONFIDENTIAL
Writer: Anna Roberts File Name: o-appe Troubleshooting Information.doc
Codename: Expedition Part Number: 270854-002 Last Saved On: 6/17/03 2:41 PM