HP XP20000XP24000 Disk Array - Manual (Page 47)

Error Code Cause Measure
2301
Auto LUN is not installed on the storage
system.
Install Auto LUN, and the perform the
volume migration.
2306
The LBA size does not match between the
migration target volume and the migration
source volume.
This volume migration cannot be executed.
Check the configuration definition file.
2309
The maximum number of pairs which can
be set in the storage system is exceeded.
Reduce the number of pairs set in the
storage system, and then perform the
volume migration.
2311
The migration target volume is already
reserved by Auto LUN.
Cancel the reservation by Auto LUN, and
then perform the volume migration.
2312
The migration source volume is online with
the host.
Make the migration source volume offline
from the host, and then perform the volume
migration.
232F
The migration source volume is already
specified as the target volume of Auto
LUN.
Release the volume from Auto LUN, and
then perform the volume migration.
2331
Either of the following causes can be
considered:
1) The migration source volume is already
reserved by Auto LUN.
2) The number of slots does not match
between the migration target volume and
the migration source volume.
Do the following measures respectively:
1) Cancel the reservation by Auto LUN,
and then perform the volume migration.
2) This volume migration cannot be
executed. Check the configuration
definition file.
2332
You cannot add pair settings any more
to the volume specified as the migration
source.
Reduce the number of pair settings of the
specified volume, and then perform the
volume migration.
2333
The volume specified by the migration
cancellation is not a migration source
volume
It is trying to perform the migration
cancellation of the pair which is not
migrating. Check the configuration
definition file.
2336
The emulation type does not match
between the migration target volume and
the migration source volume.
This volume migration cannot be executed.
Check the configuration definition file.
2337
The migration source volume is a leaf
volume of Business Copy.
Release the Business Copy pair, and then
perform the volume migration.
233B
The migration target volume is a primary
volume of Business Copy.
Release the Business Copy pair, and then
perform the volume migration.
233C
The migration target volume is a secondary
volume of Business Copy.
Release the Business Copy pair, and then
perform the volume migration.
2342
The migration target volume is already
specified as the target volume of Auto
LUN.
Release the volume from Auto LUN, and
then perform the volume migration.
2344
The volume specified by the migration
cancellation is not a migration target
volume
It is trying to perform the migration
cancellation of the pair which is not
migrating. Check the configuration
definition file.
2346
The migration target volume is a primary
volume of Continuous Access.
Release the Continuous Access pair, and
then perform the volume migration.
2347
The migration target volume is a secondary
volume of Continuous Access.
Release the Continuous Access pair, and
then perform the volume migration.
XP24000 Auto LUN Software User's Guide 47