HP Virtual Connect 8Gb 20-port Fibre Channel Module for c-Class BladeSystem - Manual (Page 112)

Virtual Connect networks 112
To delete a network configuration, click Delete, and then click Apply.
Receivers
At least one receiver and one module must be configured to collect and send data. You can add up to three
receivers to collect the sFlow data.
To add a receiver:
1. Click Add.
2. Enter a name for the receiver. The name of a receiver cannot be changed after it is created.
3. Enter the port number for the receiver. The default is 6343.
4. Enter the IP address of the receiver.
5. Set the Max Header Size. The default is 128.
6. Set the Max Datagram Size. The default is 1400.
7. Click OK.
To enable the receiver, you must configure at least one interconnect module and the associated ports. The
receiver is enabled by default.
To disable the receiver, clear the Enable check box.
To edit the receiver information, highlight the receiver in the list, and then click Edit.
To delete a receiver, highlight the receiver in the list, and then click Delete.
Modules
To configure a module:
1. Click Edit.
2. Select to Enable DHCP, or enter an IP Address (mandatory), Subnet Mask (mandatory), and Gateway
(optional).
o The sFlow module IP should not overlap with the VC/OA management IP network.
o You cannot assign the same IP address to different modules; the IP address must be unique for each
module.
3. Click OK.
4. Click Apply.
Resetting a module changes the status to "Not Running."
• To reset an individual module, click the down arrow in the Action column, and then select Reset.
This selection is only enabled if the module is configured.
• To reset all modules, click Reset All.
Reset removes any IP configuration for that module. Clicking Reset All removes any IP configuration for all
modules.
You cannot reset a module if ports are configured on it. If ports are configured on the module you want to
reset, go to the Ports tab and edit the port to stop sampling and polling.
You can delete any receivers that have ports assigned from the given module. Deleting a receiver deletes all
of the ports assigned to that receiver.
The Status column displays the current status of the modules in the enclosure, and is not editable. Statuses:
• Running—sFlow monitoring is running.