HP XP Array Manager Software - Manual (Page 38)

4. If you do not want to apply the same options to any other LDEVs, make sure that the Multi Set
/ Release box is not checked, click Set, and then click OK on the confirmation dialog box.
The requested operation is displayed in blue in the LDEV information table.
To apply the same options to additional LDEVs:
a. Select the Multi Set / Release box in the Cache Residency window, click Set, and then
click OK to open the Multi Set dialog box. The Multi Set dialog box displays the data
range and options selected in the Cache Residency window.
b. On the Multi Set dialog box, select the desired CU image, and select the desired LDEVs.
The options displayed on the dialog box will be applied to all selected LDEVs.
c. Click Set to return to the Cache Residency window. The requested Cache Residency
operations are displayed in blue in the LDEV information table.
5. Repeat steps 2 through 4 until all desired operations are listed.
Note: You cannot use the Release button until you apply (or cancel) your requested operations.
6. Verify the Pre-staging setting:
•
To enable pre-staging, select Pre-staging.
•
To disable pre-staging, clear Pre-staging.
7. To start the operations, click Apply:
•
If Pre-staging was selected, respond to the Yes/No confirmation that displays. To continue
with pre-staging, select Yes. To continue without it, select No.
•
To cancel the operation, click Cancel and click OK on the confirmation that displays.
8. Monitor the Cache Residency window to make sure that the operation(s) complete successfully.
The cache information area (see
“Cache Information Area” (page 24) ) displays the progress
of the requested operations.
Figure 18 Selecting LDEV and Specifying Options
38 Performing Cache Residency Manager Operations