Enww control-panel and status-alert messages 99 – HP Color LaserJet CP2025 Printer series User Manual
Page 109
Control-panel message
Status alert
Description
Recommended action
away from you and then press
OK
.
Manual feed <TYPE> <SIZE>
Press [OK] for available media
The product is set for manual
feed mode.
Press
OK
to clear the message
or load the correct media into
tray 1.
Memory is low
Press [OK]
Try again later or turn off & on
The product memory is almost
full.
Press
OK
to finish the job, or
press
X
to cancel the job.
Break the job into smaller jobs
that contain fewer pages.
For information about increasing
the product memory, see
memory and font DIMMs
on page 86
Misprint
Press [OK]
Print media has been delayed as
it moves through the product.
Press
OK
to clear the message.
Non HP supply installed
A non-HP supply is installed.
This message is temporary and
will disappear after several
seconds.
If you believe you purchased an
HP supply, go to
.
Service or repairs that are
required as a result of using non-
HP supplies are not covered
under HP warranty.
Order <color> cartridge
The identified print cartridge is
nearing the end of its useful life.
Order the identified print
cartridge. Printing will continue
until Replace <color> cartridge
appears.
for more
information.
Order supplies
More than one supply item is low. Check the supply-level gauges
on the control panel, or print a
Supplies status page to
determine which cartridges are
low. See
Order the identified print
cartridges. Printing will continue
until Replace <color> cartridge
appears.
for more
information.
Print failure
Press [OK] If error repeats turn
off then on
The product cannot process the
page.
Press
OK
to continue printing the
job, but output might be affected.
ENWW
Control-panel and status-alert messages
99