HP Color LaserJet CP2025 Printer series User Manual
Page 91
Print when cartridge has reached estimated end of life
An Order Supplies message appears when a print cartridge is nearing the end of its life. A Replace
supplies message appears when the print cartridge has reached its estimated end of life. To ensure
optimal print quality, HP recommends replacing a print cartridge when the Replace supplies message
appears. Print-quality problems can occur when using a cartridge that has reached its estimated end of
life, resulting in waste of print media and toner from other cartridges. Replacing a print cartridge when
the Replace supplies message appears can prevent this waste.
The Auto continue feature in HP ToolboxFX allows the product to continue using a print cartridge that
has reached the recommended replacement point.
WARNING!
Using the Auto continue feature can result in unsatisfactory print quality.
WARNING!
All print defects or supply failures incurred when an HP supply is used in cartridge-out-
override mode will not be considered to be defects in materials or workmanship in the supply under the
HP Print Cartridge Warranty Statement. For warranty information, see
Print cartridge limited warranty
.
You can enable or disable the Auto continue feature at any time, and you do not have to re-enable it
when you install a new print cartridge. When the Auto continue feature is turned on, the product
automatically continues printing when a print cartridge reaches the recommended replacement level. A
Replace Supplies Override In Use message appears while a print cartridge is being used in override
mode. When you replace the print cartridge with a new supply, the product deactivates the override
mode until another print cartridge reaches the recommended replacement level.
Enable or disable the Cartridge out override feature
1.
Open HP ToolboxFX.
2.
Click the Device Settings folder, and then click System Setup.
3.
Next to Auto continue select On to enable the feature. Select Off to disable it.
Enable or disable the Cartridge out override feature from the control panel
1.
On the control-panel menu, press
OK
.
2.
Use the
Left arrow
( ) or the
Right arrow
( ) button to select System setup, and then press
OK
.
3.
Use the
Left arrow
( ) or the
Right arrow
( ) button to select Print quality, and then press
OK
.
4.
Use the
Left arrow
( ) or the
Right arrow
( ) button to select Replace supplies, and then press
OK
.
5.
Select Override out to enable the feature. Select Stop at out to disable it.
ENWW
Manage supplies
81