HP XP Array Manager Software - Manual (Page 59)

Return Codes, Output Messages, and Error Codes 5-5
Hitachi Cache Manager User’s Guide
Error
Number
Error Message Recommended Action
JSE101I-E OPERAND ‘operand’ IS
INCONSISTENT The set of operands is inconsistent. This operand can not be used with the other specified
operand.
(S) Terminate the command process, but the next process continues. (Return code is 8.)
(P) Correct the error and execute the command again.
JSE102I-E ‘operand’ SPECIFIED BUT
REQUIRED OPERAND
MISSING The specified operand requires another operand.
(S) Terminate the command process, but the next process continues. (Return code is 8.)
(P) Correct the error and execute the command again.
JSE103I-E INVALID COMMAND
NAME ‘command name’ The [command name or PARM information] is incorrect. If the PARM information is
incorrect, the error message will indicate [PARM] in place of command name.
(S) Terminate the command process, but the next process continues. (Return code is 8.)
(P) Correct the error and execute the command again.
JSE104I-E INVALID KEYWORD
VALUE ‘keyword value’ There is an error in the [dataset name, volume serial number, dd name, disk drive unit
address, track address, or other]. For example, there may be too many characters, or
some invalid characters.
(S) Terminate the command process, but the next process continues. (Return code is 8.)
(P) Correct the error and execute the command again.
JSE105I-E INVALID KEYWORD
‘keyword value’ The specified keyword is not defined for this command.
(S) Terminate the command process, but the next process continues.(Return code is 8.)
(P) Correct the error and execute the command again.
JSE106I-E INVALID CCHH
PARAMETER The CCHH value is invalid because of one or more of the following reasons:
1. The number of characters is not eight or ten.
2. There is at least one invalid character.
3. The HH value exceeds the value of the last track number in a cylinder.
(S) Terminate the command process, but the next process continues. (Return code is 8.)
(P) Correct the error and execute the command again.
JSE107I-E LOWER LIMIT IS
GREATER THAN UPPER
LIMIT The upper value specified by CCHH parameter exceeds the maximum address of a
volume.
(S) Terminate the command process, but the next process continues. (Return code is 8.)
(P) Correct the upper CCHH value and execute the command again.
JSE2011E SPECIFIED CCHH LIMIT
EXCEEDS VOLUME
CAPACITY The upper value specified by CCHH parameter exceeds the maximum address of a
volume.
(S) Terminate the command process, but the next process goes on (return code is 8.)
(P) Correct the cchh value and execute the command again.
JSE202I-E [volume serial number or
disk DRIVE UNIT
NUMBER] IS NOT IN
CACHE SUBSYSTEM The volume specified by [DDNAME, VOLUME, or DEVICE] is not a volume in the cache
storage system. If the volume serial number is [******], a spool device or a dummy
dataset is specified.
(S) Terminate the command process, but the next process continues. (Return code is 8.)
(P) If the volume serial number is wrong, correct it and execute the command again.
JSE203I-E DATASET ‘dataset name’
DOES NOT EXIST ON
[volume serial number or
disk drive unit number] Either the dataset specified by DATASET parameter was not found in the volume defined
by the volume serial number or the disk drive unit address, or the extent number of the
specified dataset is zero.
(S) Terminate the command process, but the next process continues. (Return code is 8.)
(P) Correct the dataset name or volume serial number and execute the command again.