HP Storage Mirroring V5 Software - Manual (Page 27)

27 of 49
configure optional settings, click Configure. Once you have completed your
configuration, click Finish to start the migration.
17. Monitor the progress of the migration mirror on the Monitor page.
18. When the migration mirror has completed, the target will automatically reboot to
complete the migration process, if you disabled user intervention. If you enabled
user intervention, when the migration mirror is complete, the status will change to
Ready for Cutover. Use this time to complete any necessary tasks. When you are
ready to complete the migration, click Cutover on the Monitor page toolbar to
complete the migration process.
Once the virtual machine has been rebooted, it will become the source server.
Note:
If your source was disconnected from the network during the cutover process,
the original job that was mirroring the data will still be active on that machine.
Do not bring that machine back on the network. If you do, the original job will
attempt to begin mirroring data again which could result in data loss. While the
machine is still disconnected from the network, stop the Storage Mirroring
service, delete the file connect.sts located in the Storage Mirroring Data
Migration installation directory, and then restart the Storage Mirroring. This will
delete the original job. After the original job is deleted, you can bring the
machine on the network if desired.