HP Storage Mirroring V5 Software - Manual (Page 34)

34 of 49
Note:
If your source was disconnected from the network during the cutover
process, the original job that was mirroring the data will still be active on
that machine. Do not bring that machine back on the network. If you do,
the original job will attempt to begin mirroring data again which could
result in data loss. While the machine is still disconnected from the
network, stop the Storage Mirroring service, delete the file connect.sts
located in the Storage Mirroring Data Migration installation directory, and
then restart the Storage Mirroring. This will delete the original job. After
the original job is deleted, you can bring the machine on the network if
desired.