HP StorageWorks IP Storage Router - Manual (Page 87)

Configuring the Storage Router
87 IP Storage Router SR2122-2 User Guide
Connecting a Console
To begin configuration of your IP Storage Router 2122-2, use the command line
interface (CLI), by connecting a PC with a terminal emulation program to the
EIA/TIA-232 console interface according to the procedures in
Chapter 2,
“Installation.” Then make sure that the terminal emulation program is configured
for a CLI session with the values provided in Table 11 .
Table 11: Terminal Emulation Configuration
Apply passwords to EIA/TIA-232 console interface (yes/no)
System administrator name
System administrator e-mail address
System administrator phone number
System administrator pager number
Name of SCSI routing instance (if using the VLAN service, do not configure a
SCSI routing instance with the setup configuration wizard)
Configuration deployment option (1 or 2)
Management interface IP address and subnet mask
Configuration Item Value
Setting Value
Data bits 8
Bit per second 9600
Parity None
Stop bits 1
Flow control None