HP XP7 Storage - Manual (Page 113)

PROMPT>dlnkmgr -l set -lic
KAPL01049-I Would you like to execute the operation?
Operation name = set [y/n]: y
KAPL01083-I There is no license key file. File name
=Windows-installation-destination-drive-name\hdlm_license
KAPL01068-I Enter a license key:*************
KAPL01071-I A permanent license was installed.
PROMPT>
-audlog {on [-audlv audit-log-data-collection-level] [-
category [[ss] [a] [ca]|all]]|off}
Specifies whether to collect audit log data.
on: Audit Log data is collected.
off: Audit Log data is not collected.
-audlv audit-log-data-collection-level
Specifies the severity level of audit log data to be collected. The
table below lists and describes the values used for this setting.
The default is 6.
Table 6-4 Values Indicating Audit Log Data Collection Levels
Value (severity) Explanation
0 Error-level audit log data is collected.
1
2
3
4 Error-level and Warning-level audit log data is collected.
5
6 Error-level, Warning-level, and Information-level audit log
data is collected.
7
-category [[ss] [a] [ca]|all]
Specifies the categories of audit log data to be collected. The table
below lists and describes the values used for this setting. The
default is all. If you specify the -category parameter without
specifying a value, all is assumed.
Table 6-5 Values Indicating Audit Log Data Categories
Value Explanation
ss Audit log events of the StartStop category are collected.
a Audit log events of the Authentication category are
collected.
Command Reference
6-21
Hitachi Dynamic Link Manager (for VMware®) User Guide