HP StorageWorks 2.128 SAN Director Switch - Manual (Page 28)

28 Performing basic configuration tasks
Removing a licensed feature
1. Connect to the switch and log in as admin.
2. Issue the
licenseShow
command to display the active licenses.
3. Remove the license key using the
licenseRemove
command:
switch:admin> licenseremove “key”
The license key is case-sensitive and must be entered exactly as given. The quotation marks
are optional. After removing a license key, the optionally licensed feature is disabled when the switch
is rebooted or when a switch disable or enable is performed.
4. Issue the
licenseShow
command to verify that the license is disabled. For example:
After a reboot (or
switchDisable
and
switchEnable
):
If there are no license keys,
licenseShow
displays the message
No licenses
.
Customizing the switch name
Switches can be identified by IP address, Domain ID, WWN, or by customized switch names that are
unique and meaningful.
Version 4.0.0 (and later) switch names can be from 1 to 15 characters long, must begin with a letter, and
can contain letters, numbers, or the underscore character. It is not necessary to use quotation marks.
The default names are the following:
• For the 4/8 SAN Switch, 4/16 SAN Switch, SAN Switch 2/8V, SAN Switch 2/16V, SAN Switch
2/32, Brocade 4Gb SAN Switch for HP p-Class BladeSystem, and SAN Switch 4/32: the name is
swd77
.
• For the Core Switch 2/64: the name varies depending on the number of logical switches. The two
logical switches have different default names. The name
swd77
is used for the logical switch
containing the port blades in slots 1 through 4;
swd76
is used for the logical switch containing the
port blades in slots 7 through 10.
• For the SAN Director 2/128 and the 4/256 SAN Director: the name is
swd77
.
NOTE: Changing the switch name causes a domain address format Registered State Change
Notification (RSCN) to be issued.
Customizing the switch name
1. For the 4/8 SAN Switch, 4/16 SAN Switch, SAN Switch 2/8V, SAN Switch 2/16V, SAN Switch
2/32, Brocade 4Gb SAN Switch for HP p-Class BladeSystem, and SAN Switch 4/32: Proceed to the
next step.
For the Core Switch 2/64, SAN Director 2/128, and 4/256 SAN Director: Open a telnet window
for each logical switch and issue the
switchName
command.
switch:admin> licenseshow
bQebzbRdScRfc0iK:
Web license
Zoning license
SybbzQQ9edTzcc0X:
Fabric license
switch:admin> licenseremove “bQebzbRdScRfc0iK”
removing license key “bQebzbRdScRfc0iK”
switch:admin>
switch:admin> licenseshow
SybbzQQ9edTzcc0X:
Fabric license
switch:admin>