HP LaserJet 4250 - Manual (Page 230)

Item Values Explanation
FUSER MODES PLAIN
PREPRINTED
LETTERHEAD
TRANSPARENCY
PREPUNCHED
LABELS
BOND
RECYCLED
COLOR
LIGHT 60-75 G/M2
CARDSTOCK
ROUGH
ENVELOPE
Configures the fuser mode associated with each
paper type.
Change the fuser mode only if you are
experiencing problems printing on certain media
types. After you select a type of media, you can
select a fuser mode that is available for that
type. The printer supports the following modes:
NORMAL: Used for most types of paper.
HIGH 1: Used for rough paper.
HIGH 2: Used for paper that has a special or
rough finish.
LOW 1: Used for lightweight media. Use this
mode if you are having problems with curled
paper.
LOW 2: Used for transparencies.
CAUTION
Do not change the fuser mode for
transparencies. Failure to use the LOW 2 setting
while printing transparencies can result in
permanent damage to the printer and fuser.
Always select Transparencies as the Type in
the printer driver and set the tray type at the
printer control panel to TRANSPARENCY.
When selected, RESTORE MODES resets the
fuser mode for each media type back to its
default setting.
OPTIMIZE HIGH TRANSFER
LINE DETAIL
RESTORE OPTIMIZE
HIGH TRANSFER: Set to ON if you are using
highly resistive, lower-quality papers. HP
recommends using only HP paper and print
media.
LINE DETAIL: Set to ON to improve the
appearance of lines if scattered lines are
appearing.
RESTORE OPTIMIZE: Returns to the defaults
for the Optimize settings.
218 Appendix B Control panel menus ENWW