HP OFFICEJET 4500 - Manual (Page 59)

NOTE: If you have questions about Internet faxing, contact your Internet faxing
services support department or your local service provider for further assistance.
Use reports
You can set up the device to print error reports and confirmation reports automatically for
each fax you send and receive. You can also manually print system reports as required;
these reports provide useful system information about the device.
By default, the device is set to print a report only if there is a problem sending or receiving
a fax. A confirmation message that indicates whether a fax was successfully sent appears
briefly on the control-panel display after each transaction.
NOTE: If the reports are not legible, you can check the estimated ink levels from the
control panel, HP Solution Center (Windows), or HP Utility (Mac OS X).
NOTE: Ink level alerts and indicators provide estimates for planning purposes only.
When you receive a low-ink alert, consider having a replacement cartridge available
to avoid possible printing delays. You do not need to replace the ink cartridges until
print quality becomes unacceptable.
NOTE: Ensure that the printhead and ink cartridges are in good conditions and
installed properly.
This section contains the following topics:
•
Print fax confirmation reports
• Print fax error reports
• Print and view the fax log
• Clear the fax log
• Print the details of the last fax transaction
• Print a Caller ID History Report
Print fax confirmation reports
If you require printed confirmation that your faxes were successfully sent, follow these
instructions to enable fax confirmation before sending any faxes. Select either On Fax
Send or Send & Receive.
The default fax confirmation setting is Off. This means that a confirmation report is not
printed for each fax sent or received. A confirmation message indicating whether a fax
was successfully sent appears briefly on the control-panel display after each transaction.
NOTE: You can include an image of the first page of the fax on the Fax Sent
Confirmation report if you choose On Fax Send or Send & Receive, and if you scan
the fax to send from memory.
To enable fax confirmation
1. Press the (Setup) button.
2. Press right arrow to select Print Report, and then press OK.
Use reports 55