HP StorageWorks 2.32 Edge Switch - Manual (Page 202)

Informational and error messages 202
Are you sure you want to
delete firmware version?
This message requests
confirmation to delete a
firmware version.
Firmware library can
store up to 8 firmware
versions.
Click Yes to delete the firmware
version or No to abort the
operation.
Are you sure you want to
delete this address
configuration?
Confirmation to delete
the selected address
configuration.
Click Yes to confirm the deletion
of the address configuration or No
to cancel the operation.
Are you sure you want to
send firmware version?
This message requests
confirmation to send a
firmware version from the
HAFM appliance’s
firmware library to the
director. Firmware library
can store up to 8
firmware versions.
Click Yes to send the firmware
version or No to abort the
operation.
Cannot change Port Type
while Management Style
is FICON without
SANtegrity feature.
Please contact your sales
representative.
Firmware is below the
required level and you
attempted to change a
port type in the Configure
Ports dialog box while
FICON management
style, but the optional
SANtegrity Binding
feature is not installed.
Informational message. If the
firmware is below the required
level, install SANtegrity Binding
before changing port types in the
Configure Ports dialog box while
in FICON management style.
Cannot disable Switch
Binding while Enterprise
Fabric Mode is active
and the switch is Online.
You attempted to disable
Switch Binding through
the Switch Binding
Change State dialog
box, but Enterprise Fabric
Mode is enabled.
You must either disable Enterprise
Fabric Mode using the Enterprise
Fabric Mode dialog box in the
HAFM application or set the switch
offline before you can disable
Switch Binding.
Cannot disable Insistent
Domain ID while Fabric
Binding is active.
You attempted to disable
the Insistent Domain ID
parameter through the
Configure Switch
Parameters dialog box,
but Fabric Binding is
enabled.
Disable Fabric Binding through the
Fabric Binding dialog box before
disabling these parameters.
Cannot enable
beaconing on a failed
FRU.
Occurs when selecting
Enable Beaconing option
for a failed FRU.
Replace FRU and enable
beaconing again or enable
beaconing on operating FRU.
Table 24 Element Manager Messages (continued)
Message Description Action