Event notification – HP VMA-series Memory Arrays User Manual
Page 162
162
HP VMA SAN Gateway User’s Guide
AM456-9026A
Enable or disable NTP overall. Note that the latter is the Cisco command; the former is just a pair
of aliases added to increase usability, as otherwise it may be hard for a user to figure out how to
enable NTP if they are not aware of
no
commands and only see a way to disable it.
Display NTP Settings
show ntp
Display current NTP settings.
Event Notification
This section provides the syntax for event notification commands, along with an explanation of the
functionality of each command.
Enable or Disable Email Notifications
[no] email enable
Enable or disable the sending of email when certain events occur. These events are the same as those
for which SNMP traps can be sent (see
Set or Clear the Mail Relay
email mailhub <hostname>
no email mailhub
Set or clear the mail relay to use to send notification e-mails.
Specify the Mail Relay Port
email mailhub-port <TCP port>
no email mailhub-port
Set the mail relay port to use to send notification e-mails. The
no
variant resets the port to its default,
which is 25.
Specify the Email Notifications Domain Name
email domain <domain name>
no email domain