Addonics Technologies HDUS11325DX - Manual (Page 14)

www.addonics.com Technical Support (M-F 8:30am - 6:00pm PST) Phone: 408-453-6212 Email: www.addonics.com/support/query/
All data will be
lost,Erase? No
Press ENT again and the LCD will prompt you to confirm the erase operation.
Full Erase HDD
This function is used to full erase all data on the HDD. Please backup any important data before
using this function.
11-05.Adv Setup
Full Erase HDD
Quick Erase HDD
ALL/Target CH:*
Press ENT to enter the following screen. Use the Up and Down buttons to select the HDD to
erase.
All data will be
lost,Erase? No
Press ENT again and the LCD will prompt you to confirm the erase operation.
Test IDE 0/1
OK
LCD Test Start Button Test ? SDRAM Test:
8192Kbytes OK
FlashTest: OK Test finished
Once the system diagnostics have been completed the "Test finished" message will appear on the
LCD.
Press ENT and the system will begin the tests as shown below.
H/W Diagnostic
Press ENT to enter the following screen. This function is used to check that the system is
operating normally.
11-06.Adv Setup
H/W Diagnostic
Press ENT again to enter the following screen. The LCD will cycle through the test categories as
they are performed. The LCD display is tested first, the control panel is tested next (requires
manual operation), then followed by the system's internal diagnostics, hardware connection test
then the RAM and SD Flash test. All test results are shown on the LCD. This is a simple way to
verify that the system is operating normally.