Addonics Technologies HDUS11325DX - Manual (Page 15)

www.addonics.com Technical Support (M-F 8:30am - 6:00pm PST) Phone: 408-453-6212 Email: www.addonics.com/support/query/
Press ENT to enter the following screen. Use the Up and Down buttons to confirm reset to factory
defaults.
Load Default
Config? Yes
Load Default
Ok
If Load Default OK, this will be displayed on the LCD as shown below.
Load Default
Press ESC to return to the main menu then use the ENT button to select. This function resets all
settings to their factory default. This function helps the system recover from errors caused by an
illegal operation.
11-07.Adv Setup
Load Default
Burn In
This function is used to burn test the system reliability.
11-09. Adv Setup
Burn In
Press ENT to enter the following screen.
Burn In Mode
Copy & Compare
Use the Up and Down buttons to choose Compare, Async Copy & Cmp and Async Compare, then
press ENT to confirm.
Copy HPA
If this function is set to "ON", the system will completely copy the data in a source HDD's host
protected area.
11-08. Adv Setup
Copy HPA
The default is "OFF". Use the ENT , Up and Down buttons to change this to "On".